Hi guys!
I need help about the Dlink DWA-548 (Pci interface) with RT5392 Chipset and rt2800pci driver.
The Wi-fi card doesn't work, sometimes it seems that it will connect, it stays loading but never connects.
I have been reading this posts:
https://ubuntuforums.org/showthread....=RALINK+RT5392
https://ubuntuforums.org/showthread.php?t=2071830
https://forums.linuxmint.com/viewtopic.php?t=257974
https://ubuntuforums.org/showthread....ralink+drivers
Also, I have tried with this commands (but still not working):
sudo lshw -C network
ifconfig
iwconfig
lspci -nn | grep 0280
lspci -nnk | grep -iA2 net
lspci -vvnn | grep Network
lspci -vvnn | grep -A 9 Network | grep Kernel
sudo modprobe rt2800pci
dmesg | grep rt2
I tried this command, but I think there's nothing to delete (because I can't see/find a ndiswrapper folder in etc directory):
sudo rm -rf /etc/ndiswrapper/*
Thanks,
Jorge A.
I need help about the Dlink DWA-548 (Pci interface) with RT5392 Chipset and rt2800pci driver.
The Wi-fi card doesn't work, sometimes it seems that it will connect, it stays loading but never connects.
I have been reading this posts:
https://ubuntuforums.org/showthread....=RALINK+RT5392
https://ubuntuforums.org/showthread.php?t=2071830
https://forums.linuxmint.com/viewtopic.php?t=257974
https://ubuntuforums.org/showthread....ralink+drivers
Also, I have tried with this commands (but still not working):
sudo lshw -C network
Code:
*-network
description: Wireless interface
product: RT5392 PCIe Wireless Network Adapter
vendor: Ralink corp.
physical id: 0
bus info: pci@0000:03:00.0
logical name: wlp3s0
version: 00
serial: 54:b8:0a:01:0c:69
width: 32 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=rt2800pci driverversion=4.18.20-041820-generic firmware=0.40 latency=0 link=no multicast=yes wireless=IEEE 802.11
resources: irq:29 memory:f7600000-f760ffff
*-network
description: Ethernet interface
product: RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:04:00.0
logical name: enp4s0
version: 0c
serial: e0:d5:5e:e4:b4:79
size: 10Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=half firmware=rtl8168g-2_0.0.1 02/06/13 latency=0 link=no multicast=yes port=MII speed=10Mbit/s
resources: irq:34 ioport:f000(size=256) memory:f7500000-f7500fff memory:f0000000-f0003fff
*-network
description: Ethernet interface
physical id: 1
logical name: enp1s0f0u4
serial: 4e:92:e1:cf:33:b6
capabilities: ethernet physical
configuration: broadcast=yes driver=rndis_host driverversion=22-Aug-2005 firmware=RNDIS device ip=192.168.42.174 link=yes multicast=yesifconfig
Code:
enp1s0f0u4: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.42.174 netmask 255.255.255.0 broadcast 192.168.42.255
inet6 fe80::5a50:55b1:e15b:5615 prefixlen 64 scopeid 0x20<link>
ether 4e:92:e1:cf:33:b6 txqueuelen 1000 (Ethernet)
RX packets 52233 bytes 52593781 (52.5 MB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 40403 bytes 6343941 (6.3 MB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
enp4s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether e0:d5:5e:e4:b4:79 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 11161 bytes 1069055 (1.0 MB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 11161 bytes 1069055 (1.0 MB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlp3s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 54:b8:0a:01:0c:69 txqueuelen 1000 (Ethernet)
RX packets 3917 bytes 5205400 (5.2 MB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 2030 bytes 201409 (201.4 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0Code:
enp1s0f0u4 no wireless extensions.
enp4s0 no wireless extensions.
wlp3s0 IEEE 802.11 ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm
Retry short long limit:2 RTS thr:off Fragment thr:off
Power Management:on
lo no wireless extensions.Code:
03:00.0 Network controller [0280]: Ralink corp. RT5392 PCIe Wireless Network Adapter [1814:5392]Code:
03:00.0 Network controller [0280]: Ralink corp. RT5392 PCIe Wireless Network Adapter [1814:5392]
Subsystem: D-Link System Inc RT5392 PCIe Wireless Network Adapter [1186:3c06]
Kernel driver in use: rt2800pci
Kernel modules: rt2800pci
04:00.0 Ethernet controller [0200]: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller [10ec:8168] (rev 0c)
Subsystem: Gigabyte Technology Co., Ltd Onboard Ethernet [1458:e000]
Kernel driver in use: r8169
Kernel modules: r8169Code:
03:00.0 Network controller [0280]: Ralink corp. RT5392 PCIe Wireless Network Adapter [1814:5392]
Subsystem: D-Link System Inc RT5392 PCIe Wireless Network Adapter [1186:3c06]Code:
Kernel driver in use: rt2800pci
Kernel modules: rt2800pcisudo modprobe rt2800pci
dmesg | grep rt2
Code:
[ 17.175187] ieee80211 phy0: rt2x00_set_rt: Info - RT chipset 5392, rev 0223 detected
[ 17.178792] ieee80211 phy0: rt2x00_set_rf: Info - RF chipset 5392 detected
[ 17.400570] rt2800pci 0000:03:00.0 wlp3s0: renamed from wlan0
[ 32.715098] ieee80211 phy0: rt2x00lib_request_firmware: Info - Loading firmware file 'rt2860.bin'
[ 32.739018] ieee80211 phy0: rt2x00lib_request_firmware: Info - Firmware detected - version: 0.40
[ 54.680200] rt2800pci 0000:03:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x0000 address=0x00000000ff968000 flags=0x0000]
[ 55.384075] ieee80211 phy0: rt2x00queue_flush_queue: Warning - Queue 0 failed to flush
[ 56.916176] ieee80211 phy0: rt2x00queue_flush_queue: Warning - Queue 0 failed to flush
[ 57.516054] ieee80211 phy0: rt2x00queue_flush_queue: Warning - Queue 2 failed to flush
[ 58.216054] ieee80211 phy0: rt2x00queue_flush_queue: Warning - Queue 0 failed to flushI tried this command, but I think there's nothing to delete (because I can't see/find a ndiswrapper folder in etc directory):
sudo rm -rf /etc/ndiswrapper/*
Thanks,
Jorge A.